![](/images/new-backgrounds/1265350/26535047x1.webp)
Setting the SCSI ID and Terminator
Set the SCSI ID and terminator using the DIP switch on the rear of the scanner. The DIP switch is ON at the up position and OFF at the down position.
Default
(Terminator: OFF, SCSI ID = 2)
SCSI ID switch Terminator ON/OFF switch
■Setting the SCSI ID
Set the SCSI ID by combining the settings of switches SW2 to SW4. Set unique SCSI IDs to any other
SCSI ID | SW2 | SW3 | SW4 |
0 | ON | ON | ON |
1 | ON | ON | OFF |
2 | ON | OFF | ON |
3 | ON | OFF | OFF |
4 | OFF | ON | ON |
5 | OFF | ON | OFF |
6 | OFF | OFF | ON |
7 | OFF | OFF | OFF |
NOTE
The default SCSI ID is set to 2. Assign SCSI ID numbers ranging from 0 to 7 for each SCSI device. Do not select 7 as this is normally assigned to the SCSI controller. If a SCSI hard disk is set as the startup disk, do not use 0. Normally 0 is assigned for the startup disk.
22Connecting to a Computer