Using RF Cable | Canon DT 9500 CI manual

2. Setup

3. Using RF Cable

1.Connect the antenna to the LNB IN of the product.

2.The RF cable is connected as in the figure above.

Note: The default UHF channel is 36.

GB 14

Image 15

Canon DT 9500 CI user manual Using RF Cable

Contents

Digital Satellite Receiver CryptoWorks Embedded Page Safety Warning Contents Contents Package Contents Before Using the Product Digiturk CH LED Front Panel RF OUT Rear Panel Inserting Smartcard Conditional Access Inserting CI Common Interface Module Guide EPG Remote Control Freeze Setup Connecting Antenna/TV/VCRUsing Scart Cable Using RCA Cable Using RF Cable Connecting Audio System Powering On Basic Operation Installation Wizard Banner Programme Information Viewing Programme Soundtrack Subtitle Teletext Menu Map Menu Map Installation Digiturk InstallationChange CAS Slot of All Digiturk Channels Antenna Setting Advanced Installation Manual Search DiSEqC Command Mode Movement Motor Control Satellite Setting Motor Limit Setting Automatic Search Desired Symbol Rate Organise All Channels Organise Channels Organise Favourite A~B Organise Satellites Factory Settings System Settings Language SettingTime and Date Setting UHF Tuning A/V Output Setting Other Setting System Information Front Panel Lock Parental ControlParental Rating Modify PIN code Channel List Switching Channels Setting Property of Channel Favourite List Games UtilityCalendar Biorhythm Programme Guide Reserve the programme once a week Mail Conditional Access Common Interface OTA Over the Air Software Upgrade Software Upgrade No picture Troubleshooting Reservation is unavailable Mpeg Transport Stream A/V Decoding Specification