Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide.
Power SourceThe battery |
| You are using the wrong battery. |
| |
cannot be |
| s Use the dedicated | ||
recharged. |
| The battery is not properly attached to the charger. | ||
|
|
| ||
|
|
| s Attach the battery properly to the charger. (→p.22) | |
The camera does | The battery is exhausted. |
| ||
not operate even | s Recharge the battery. (→p.22) |
| ||
when the < | > | The battery is not installed properly. | ||
switch is set to | s Install the battery properly. (→p.23) | |||
< | >. |
| The CF card slot cover is open. |
|
|
|
|
| |
|
|
| s Push in the CF card until the CF card release button pops up. Then | |
|
|
| close the CF card slot cover. (→p.27) | |
The access lamp | If you set the < > switch to < | > right after taking a picture, the | ||
still blinks even | access lamp will still blink for a few seconds while the image is recorded | |||
when the < | > | onto the CF card. |
| |
switch is set to | s When the camera finishes recording the image to the CF card, the | |||
< | >. |
| access lamp will stop blinking and the power will turn off. | |
The battery |
| The battery is not fully charged. |
| |
becomes |
| s Recharge the battery fully. (→p.22) | ||
exhausted |
| The battery’s service life has expired. | ||
quickly. |
| |||
| s Replace the battery with a new one. (→p.166) | |||
The camera turns | Auto power off is in effect. |
| ||
off by itself. |
| s Set the < > switch to < > again or set auto power off to “Off.” | ||
|
|
| (→p.130) |
|
Only the <
> The battery has almost exhausted. icon is displayed on s Recharge the battery. (→p.22) the top LCD panel.
162