Canon Remote Camera Triggering, Slide the FlexTT5 onto the shoe of the remote camera to

Remote Camera Triggering

As with other PocketWizard radios, the MiniTT1 and FlexTT5

can be used to trigger a remote camera. To perform this operation a PocketWizard motor drive cable is required. For cameras with Canon’s E3 connector, you need the PocketWizard CM-E3-ACC cable. For cameras with Canon’s N3 Motor drive connector, you need the CM-N3-ACC cable.

1. Slide the FlexTT5 onto the shoe of the remote camera to

be triggered.
2. Connect the motor drive cable from	port on the

FlexTT5 to the remote terminal on the camera.

3. Use the MiniTT1 or any PocketWizard Transmitter to trigger
If you are using the MiniTT1 radio as the transmitter, be sure
to hold it properly to maximize range. Using the MiniTT1 in this
manner causes a large drain on the coin cell battery. To maintain
	FlexTT5 connected to remote camera
the best battery life, use a FlexTT5 or another PocketWizard as
the hand held transmitter.
NOTE: With this remote camera setup you are engaging
Auto-Relay Mode and sending triggers one channel higher. Read
more about that mode for information about using a camera with
remote flash.
NOTE: The FlexTT5 should be in the shoe of the remote camera
to be triggered. Removing it from the shoe may cause unwanted
triggering to occur.
NOTE: Continuous motor drive triggering of remote cameras is
not available. Single shot mode is required.

26 Hold up and away for best range