Canon FlexTT5, MiniTT1 owner manual Reset, Default Settings

Reset

The MiniTT1 and FlexTT5 can be reset in the field. There are two types of reset.

RESET A: Returns both C.1 and C.2 to the channels you last set in the PocketWizard Utility. Reset A is primarily used for resetting channels that were taught in the field.

1.	Turn the radio off
2.	While holding TEST, slide the power switch to C.1 (C.1 and C.2
		Flex TEST button
	are always reset together).

3.Hold TEST for a few moments until you see 2 green blinks, then release TEST. The channels are restored to their last Utility values. If you’ve never set the channels using the Utility, then the channels are restored to factory defaults.

RESET B: Returns all of your radio’s settings, including channels and all settings from the PocketWizard Utility, to factory defaults.

1.Turn the radio off

2.While holding TEST, slide the power switch to C.1 (C.1 and C.2 are always reset together).

3.Hold TEST for ~10 seconds until you see 4 green blinks, then release TEST. The radio is reset to factory defaults.

Default Settings:

ControlTL Tx Channel = 1	HyperSync Offset = -170
Standard Tx Channel = 1	Remote TTL Flash Sleep Delay = Disabled
Use ControlTL for Rx Channel = Enabled	Flash Idle Time Out Mode = Disabled
ControlTL Rx Channel = 1	Force TTL Master Mode = Disabled
Camera Model = Auto	Bottom Shoe = Enabled

28