Photos

Refer to this chapter for details on shooting photos – from capturing and playing back images to printing them.

Basic Recording

Taking Photos

( 26)

1Set the mode dial to .

2Turn on the camcorder.

You can select the memory to be used for recording still images

( 33).

3 Press PHOTO halfway.

Once the focus is automatically

adjusted, will turn green and one or more AF frames will appear.

When you press PHOTO on the wireless controller, the still image is

recorded after the autofocus is activated and locked.

4 Press PHOTO fully.

The ACCESS indicator will flash as the still image is being recorded.

IMPORTANT

Observe the following precautions while the ACCESS indicator is on or flashing. Failing to do so may result in permanent data loss.

-Do not open the memory card slot cover.

-Do not disconnect the power source or turn off the camcorder.

-Do not change the position of the mode dial.

NOTES

If the subject is not suitable for

autofocus, turns yellow. Adjust the

focus manually ( 50).

When the subject is too bright, “OVEREXP.” starts flashing. In such case, use the optional FS-H37U ND filter.

Selecting Photo Size and Quality

Still images are recorded as JPG files. As a general rule, select a larger image size for higher quality. Select the

[LW 1920x1080] size for photos with an aspect ratio of 16:9.

61

Page 61
Image 61
Canon HF10 instruction manual Taking Photos, Selecting Photo Size and Quality, Press Photo halfway, Press Photo fully