21Before Using Your Machine

ENGLISH
Loading Documents and Paper
1Open the Document Cover (1) and extend the
Paper Support (2) to support the paper.
2Squeeze, then slide the Paper Guide to the
left.
3Insert the stack face up into the Rear Tray (1),
and align the right edge of the stack with the
right side of the Rear Tray. Then slide the
Paper Guide (2) snugly against the left edge
of the stack.
zDo not load higher than the paper limit mark ( ).
zBe careful not to press the Paper Guide strongly
against the stack, or the paper will not be fed
properly.
4Gently insert the top of the document face up
into the ADF until you hear a beep, adjust the
Document Guide to the width of the
document.
zTo avoid feeding problems, make sure the
document meets the document requirements (see
page19 ).
Note
zFor a multipage document, the pages are fed one by one from the top of the stack.
zWait until all pages of your document have been scanned before starting a new job.
zMake sure you follow the procedure to load documents into the ADF. If the document is not loaded into
the ADF correctly, it may not be fed into the fax properly; resulting in a jam, or in pages not being sent.
zIf you want to send a document with more than 20 (10 legal-size) pages, divide the document into
sections and send each section in a separate transmission.
zFor multipage documents, tap the stack on a flat surface to even the edges before loading.
(1)
(2)
(1)
(2)
(1)
(2)