Using the Scan to E-Mail Feature

To set up and use the Scan to E-Mail feature, you need to make settings based on the flow below.

Setting up the E-Mail Send Feature (P. 19)

Using the Remote UI, you make settings to send e-mails.

Setting up the E-Mail Reception Feature (P. 28)

You make settings to receive e-mails.

If you want to use the Scan to E-mail feature only, you don’t need to make this setting.

Registering E-Mail Addresses (P. 23)

Using the Remote UI, you register the e-mail addresses.

Test Sending an E-Mail (P. 25)

You send an e-mail to a registered address for testing the feature.

The setup is completed.

Feature Mail-E to Scan the Using

18