Protecting tapes from accidental erasure

E

REC

SAVE

REC

SAVE

To protect your recordings from accidental erasure, slide the tab on the cassette to the left. (This switch position is usually labelled SAVE or ERASE OFF.)

If you load a protected cassette in CAMERA mode, the message “THE TAPE IS SET FOR ERASURE PREVENTION” appears for approx. 4 seconds and v starts flashing. If you wish to record on that cassette, slide the tab back to the right.

Cassette Handling Precautions

Do not use tapes that have been jammed as video heads may become dirty.

Rewind tapes after use. If the tape becomes slack and damaged, it may cause picture and sound distortion.

Return cassettes in the case and store them upright.

Do not leave the cassette in the camcorder after use.

Do not use cassettes with spliced tapes or nonstandard cassettes as they may damage the camcorder.

Do not insert anything into the small holes of the cassette, or cover them with cellophane tape.

Handle cassettes with care. Do not drop or subject them to severe impact as this may damage the cassettes.

Rewind tapes from time to time if they are stored for a long time.

With cassettes equipped with a memory function, metal plated terminals may become dirty with use. Clean the terminals with a cotton swab after about 10 times of loading/unloading. The memory function is not supported by the camcorder.

Mastering the Basics

17

Page 17
Image 17
Canon MV6iMC instruction manual Protecting tapes from accidental erasure, Cassette Handling Precautions