CHAPTER 6 FIXING SYSTEM
6–14
COPYRIGHT
©
1998 CANON INC. CANON NP7161/NP7160 REV.0 AUG. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 6-224
[1]
[1]
[2]
Figure 6-221
[1] [1]
[2]
[3]
Figure 6-223
Figure 6-222
[1]
[1]
[2]
9. Removing the Fixing Lower Roller
1) Remove the fixing upper roller. (See p. 6-
13.)
2) Remove the bearing [1] and the fixing
lower roller [2].
10.Removing the Heat Discharge
Roller
1) Remove the fixing assembly. (See p. 6-8.)
2) Remove the two mounting screws [1], and
detach the fixing inlet guide assembly [2].
3) Remove the heat discharge roller [3].
Caution:
If you have removed the height
adjusting screw of the inlet guide, be
sure to perform the steps under
“Adjusting the Height of the Fixing
Inlet Guide.”
11.Adjusting the Height of the Fixing
Inlet Guide
Loosen the two adjusting screws [1], and
adjust the height of the fixing inlet guide [2].