Special Recording Modes
3Press the START/STOP button to begin recording.
•The camcorder automatically records at the set frame rate.
•The tally lamps illuminate.
• [S&F STBY] changes to [NS&F REC] while recording. | 91 |
|
4Press the START/STOP button again to stop recording.
•The camcorder records the clip.
•The tally lamps go out and [S&F STBY] appears at the top of the screen.
NOTES
•You can use only one special recording mode at a time. In addition, slow & fast motion mode cannot be used with double slot recording.
•While recording, you cannot change the shooting frame rate.
•For lower shooting frame rates, it may take approximately 1 second to stop recording.
•Slow & fast motion mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the video configuration.
•The time code advances while video is recorded. If the running mode of the time code (070) is set to [Free Run] or the time code is input from an external source (bonly), the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting.
•bDuring special recording mode, the time code signal will not be output from the GENLOCK/TC terminal or HD/SD SDI terminal.
•When the bit rate is set to 50 Mbps (046) during slow motion recording, relay recording is not available.
When
1 Open the [Special Rec] submenu.
[JOther Functions] 
[Special Rec]
2 Select [Pre Rec] and then press SET.
• [PRE REC STBY] appears at the top of the screen.
3 Press the START/STOP button to begin recording.
•The tally lamps illuminate.
•[PRE REC STBY] changes to [NPRE REC] while recording.
4 Press the START/STOP button again to stop recording.
[JOther Functions]
[Special Rec]
[Off]
•The camcorder records the clip, including approximately 3 seconds of video and audio recorded before the START/STOP button was pressed.
•The tally lamps go out and [PRE REC STBY] appears at the top of the screen.