52C,P
SERIES
4.Remove the thermostat capillary from the outdoor coil and clip any wire ties holding the capillary in place.
5.Disconnect the wires and carefully remove the thermostat and capillary from the unit, noting location of wires for easy
6.Reverse Steps
■CAPACITOR — To remove the capacitor, perform the following steps:
1.Turn off unit power as described in UNIT DISASSEMBLY section.
2.Open the control box as detailed in the UNIT DISASSEMBLY section of this manual.
3.Properly discharge the capacitor as described in the Capacitor section under Component Opera- tion and Troubleshooting.
4.Remove the leads to the capacitor. Note the wire locations to ease
5.Remove the screw holding the capacitor.
6.Remove capacitor.
7.Reverse Steps
■FAN CYCLE SWITCH — The fan cycle switch is located on the front of the control box. To remove the fan cycle switch, perform the following steps:
1.Turn off unit power as described in UNIT DISASSEMBLY section.
2.Open the control box as described in UNIT DISASSEMBLY section of this manual.
3.Remove the 3 wires from the fan cycle switch. See Figure 54 for location, noting location of wires for
4.Push the snaps of the switch housing toward the switch with a pair of pliers or small screwdriver. Gently push the switch out of the housing.
5.Reverse Steps
■SELECTOR SWITCH — To remove the selector switch from the unit, perform the following steps:
1.Turn off unit power as described in UNIT DISASSEMBLY section.
2.Remove selector switch knob. See Figure 53.
3.Open control box as described in the UNIT DISASSEMBLY section of this manual.
4.Remove all the wires to the selector switch. Label wires to simplify
5.Remove the 2 screws mounting the switch and remove switch.
6.Reverse Steps
| CAPACITOR |
| OUTDOOR FROST |
| THERMOSTAT |
| POWER CORD |
| RIBBED WIRE (L2) |
| TO CAPACITOR (C) |
| POWER CORD |
| PLAIN WIRE (L1) |
GROUND SCREW | TO ROTARY SWITCH |
FAN CYCLE |
|
SWITCH |
|
INDOOR |
|
THERMOSTAT | SELECTOR |
| SWITCH |
FIGURE 54 — COMPONENT LOCATIONS
IN OPEN CONTROL BOX
28
