Single T1 PPP | Carrier Access Adit 3500 instruction

Quick Start Guide

Basic Configuration

Configure WAN Interface for Internet Connectivity

There are options to this WAN configuration. This is the connection to the end user’s internet provider. It can be the following:

zSingle T1 (PPP)

zMultiple T1s (Multilink)

zEthernet WAN

Single T1 (PPP)

To configure a single T1 utilizing PPP:

1.Select Network Connections from the Navigation bar.

2.Select (click) a T1 Interface (from T1 1 - T1 4) to configure, T1 1 is recommended.

Note: Using T1 1 and the preconfigured Serial 1 makes this configuration very simple. If you use T1 2-T1 4, you will need to delete the preconfigured Serial 1 and make a New Connection (Serial 1) based on the T1 2-T1 4 that you selected.

Adit 3500 - Release 1.6

31

Image 31

Carrier Access Adit 3500 quick start Configure WAN Interface for Internet Connectivity, Single T1 PPP

Contents

Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD Precautions User Safety Installation Environment Wall Mounting Rack Mounting Battery Backup Installation Compliant Installation Ferrite beads shipped with Adit chassis Ferrite Beads Wall Mounting See Installation Environment on To rack mount the Adit 3000, follow the instructions below Rack Mounting Tray Slide Installation Battery Backup #1 Adit 3500 mounted on top of the Battery Backup Attach Adit 3500 to the assembled BBU and brackets Attach power cords3500 Mount the Battery Backup to the wall with 4 #6 screws, by #2 Adit 3500 and Battery Backup mounted to the wall Back Adit 3500 Battery Backup Power ConnectorChassis Overview Front Back of Adit Interface ConnectorsGrounding the Unit Front of Adit Input VAC Power ConnectionBattery Connection Specification State Description DS1/E1 Connection PortsDS1/E1 RJ-48C Pin Name Description Ethernet RJ-45 10/100Base-TX Ethernet Pin Direction Description Reset ButtonRJ-11 Connector RS-232 Craft Port Female DB-9 Critical Alarm/Status LEDs #show interface ethernet 2 Eth WAN To access the management consoleCommand Description Web-Based Management Set the New-line/Transmit value CR+LF Setting up a CLI Connection Log Key Enabled Software Features Key Enabled Software Features Setup Adit 3500 for access via Web-Browser Basic Configuration Select Restore Defaults Restore Factory Defaults Modify Default Admin User Quick Start Guide Single T1 PPP Configure WAN Interface for Internet Connectivity Set the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway Select Use SIP Proxy and enter SIP Proxy IP address On the IP Telephony tab, under Proxy Servers Quick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release