Quick Start Guide

Basic Configuration

Basic Configuration

The following configuration is divided into logical sections, where each section configures an additional function. The first must be configured before the second and so forth, however, you may stop at any section and not add the following feature.

NOTE: The order in which commands are entered can affect the successful provisioning of the Adit 3500.

zSetup Adit 3500 for access via Web-Browser

zRestore Factory Defaults

zModify Default Admin User

zConfigure WAN Interface for Internet Connectivity

zConfigure the Adit 3500 as a SIP Gateway

Setup Adit 3500 for access via Web-Browser

The following steps will configure the Adit 3500 to allow access to the Web Browser for configuration, through the LAN (1) or WAN (2) 10/100Base-T Ethernet connections.

Note: for LAN access, no additional configuration is required to access the Adit using the web browser. To configure the WAN access:

1.Connect to the CLI via the DB-9 RS-232. See Setting up a CLI Connection on page 24.

2.Enable the remote admin WAN access with the following command sequence:

Command

Description

Username: admin

Log into the system (username and password).

Password: ********

 

Adit 3500> enable

Enter the Privileged mode.

Password: ********

Enter password for the Privileged mode.

#configure terminal

Enter the Configuration mode.

(config)# remote-admin web

Enable remote web admin.

primary-port enable

 

Adit 3500 - Release 1.6

27

Page 27
Image 27
Carrier Access quick start Basic Configuration, Setup Adit 3500 for access via Web-Browser