Carrier Access Adit 3500

Adit 3500 - Release 1.6 11

Quick Start Guide

Installation

4. Place the Adit 3000 on the Tray Slide and attach with the 4 screws removed in step 2.

5. Slide the assembled piece (Adit 3000 and Tray Slide) onto the installed Rack Mounting Tray.

6. Secure the Tray Slide to the Rack Mounting Tray with the attached screws on the Tray Slide.

NOTE: The mounting brackets are designed to not allow units to be mounted closer than

recommended.

Tray Slide

screws

Contents

Main Page QUICK START GUIDE Unpacking and Inspection WARNING! Electrostatic Discharge (ESD) Precautions WARNING! Quick Start Guide Installation Environment WARNING! User Safety CAUTION! Installation WARNING! Quick Start Guide Compliant Installation NOTE: WARNING! Ferrite Beads Ferrite beads shipped with Adit chassis: Quick Start Guide Wall Mounting NOTE: Rack Mounting Page Battery Backup Quick Start Guide #1 Adit 3500 mounted on top of the Battery Backup Page Quick Start Guide #2 Adit 3500 and Battery Backup mounted to the wall Front Adit 3500 Battery Backup Chassis Overview Pinout Back Front Quick Start Guide Interface Connectors Front of Adit Back of Adit Grounding the Unit WARNING! 12 VAC Power Connection Battery Connection Quick Start Guide DS1/E1 Connection Ports 18 DS1/E1 RJ-48C 10/100Base-TX Ethernet Ethernet (RJ-45) 18 RS-232 Craft Port (Female DB-9) RJ-11 Connector Reset Button Alarm/Status LEDs LED State Description Quick Start Guide Web-Based Management To access the management console: NOTE: WARNING! Setting up a CLI Connection NOTE: Quick Start Guide Log in NOTE: Key Enabled Software Features NOTE: 26 Adit 3500 - Release 1.6 This information is also displayed with the following CLI command: Basic Configuration Setup Adit 3500 for access via Web-Browser Restore Factory Defaults Modify Default Admin User Page Configure WAN Interface for Internet Connectivity