Ethernet WAN | Carrier Access Adit 3500 instruction

Quick Start Guide

Basic Configuration

Ethernet WAN

To configure the WAN utilizing Ethernet feed:

1.Select Network Connections from the Navigation bar.

2.Select (click) the delete icon associated with the Serial 1 connection. Select OK to confirm the deletion of this connection.

3. Select (click) the Ethernet 2 (WAN Ethernet) connection to configure.

Adit 3500 - Release 1.6

41

Image 41

Carrier Access Adit 3500 quick start Ethernet WAN

Contents

Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD Precautions User Safety Installation Environment Wall Mounting Rack Mounting Battery Backup Installation Compliant Installation Ferrite beads shipped with Adit chassis Ferrite Beads Wall Mounting See Installation Environment on To rack mount the Adit 3000, follow the instructions below Rack Mounting Tray Slide Installation Battery Backup #1 Adit 3500 mounted on top of the Battery Backup 3500 Attach power cordsAttach Adit 3500 to the assembled BBU and brackets Mount the Battery Backup to the wall with 4 #6 screws, by #2 Adit 3500 and Battery Backup mounted to the wall Chassis Overview Adit 3500 Battery Backup Power ConnectorFront Back Grounding the Unit Interface ConnectorsFront of Adit Back of Adit Battery Connection VAC Power ConnectionSpecification Input DS1/E1 RJ-48C DS1/E1 Connection PortsPin Name Description State Description Ethernet RJ-45 10/100Base-TX Ethernet RJ-11 Connector Reset ButtonRS-232 Craft Port Female DB-9 Pin Direction Description Critical Alarm/Status LEDs Command Description To access the management consoleWeb-Based Management #show interface ethernet 2 Eth WAN Set the New-line/Transmit value CR+LF Setting up a CLI Connection Log Key Enabled Software Features Key Enabled Software Features Setup Adit 3500 for access via Web-Browser Basic Configuration Select Restore Defaults Restore Factory Defaults Modify Default Admin User Quick Start Guide Single T1 PPP Configure WAN Interface for Internet Connectivity Set the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway Select Use SIP Proxy and enter SIP Proxy IP address On the IP Telephony tab, under Proxy Servers Quick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release