Casablanca Fan Company C15G624L owner manual Automatic Demonstration Program, Operation Safe-Exit

Direct - Touch

Automatic Demonstration Program

1 2

0

4 3

Programmed into every Direct-Touch fan is an Automatic Demonstration Program. It can be used to fully demonstrate and test the operation of the fan.

To enter the demonstration program:

1.	Turn the		power button off for at least 5 seconds.This will clear
	the fan	memory ready for programming.
2.	Turn the		power button on.

3.  Immediately hold the "0" button for at least 5 seconds.

A multi-tone signal will verify the start of the test program.The fan and lights will go through a series of changing fan speeds, reversing the fan operation mode, turning off/on, and dimming the lights.

The complete cycle lasts slightly over one minute. It will continue to

repeat until the is turned off for more than five seconds, cancelling the program.

Operation Safe-Exit®

Note: With CFL mode active, the lights will not dim.

The Safe-Exit Program gives you about thirty seconds of light when you turn the lights off, enabling you to exit your home before the lights go out.To enter the Safe- Exit Program:

1.  Press the	power button off for at least five seconds.	Safe-Exit
2.  Turn the Power on. Immediately press and hold the "4" button for 5 seconds.

When a light button is pressed, an audio tone and series of lights blinking will indicate the program is active. When CFL mode is disabled, the Lights will stay on at 50% brightness for 20 seconds then decrease in intensity for 30 seconds then turn off.

3.  With CFL mode active, the lights will turn off after 30 seconds.

4.  To cancel the Safe-Exit Program, press the power button and leave off for five seconds.

Light-minder® Program

The Light-Minder Program automatically turns OFF the fan mounted lights after two hours.To enter the Light-Minder Program:

1.	To operate the lights for Light Minder Program –Turn the			power button off
	for at least 5 seconds.
2.	Turn the		on. Immediately press and hold the "1" button for 5 seconds. A
	series of	tones will be heard through the piezo-buzzer indicating the command
	has been accepted. Once the lights turn on, they will automatically turn off after
	2 hours.				Light-Minder
3.  Light operation still remains normal, if you leave the room and turn OFF the
	lights, the lights will blink to indicate the Light Minder command has been
	accepted.The lights will stay on for 2 hours and then begin to dim. After thirty seconds have elapsed,
	the lights will turn completely off. In CFL Mode, the lights will not dim, but shut off after 2 hours.

4.  To cancel the Light Minder Program, press the power button and leave off for five seconds.

21