Mounting Bracket Installation (CONT.)
Step 3. Align the slotted holes in the ceiling plate with the pilot holes you drilled in the wood support structure. For proper alignment use slotted holes directly across from each other.
Note: The isolators should be flush against the ceiling.
Step 4. Place a flat washer on each of the two 3” wood screws and pass the screws through the slotted holes in the ceiling plate into the pilot holes you drilled.
Step 5. Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten.
Joist
Ceiling Fan
Approved 
Washer
Wiring Box
Wood
Screw
Note: On sloped ceilings, align the canopy opening toward the top or peak of the room.
Pipe Scroll Hardware
ALLEN SET |
| Decorative Scroll | Scroll |
| |
SCREW | Scroll Bracket | Decorative Scroll | |||
Screws (3) | Screws (3) | ||||
| Arm (3) | ||||
|
|
|
| ||
Screwdriver |
|
|
| Allen | |
Canopy | Trim Ring | Wrench | |||
|
| ||||
|
|
| |||
Pipe Scroll Assembly
Step 1. Remove the Paper Shield from the top of the motor.
Step 2. Using the Allen Wrench, loosen the Set screw at the top of the Scroll Assembly, and on the Motor Adapter on the top of the Motor.
Step 3. Remove theTrim Ring from the Canopy.
Step 4. Insert the Pipe Assembly through the Canopy first,Trim Ring second, and finally the Scroll Bracket.
Step 5. Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal dowel pin inside the dowrod.
Pipe Assembly
Canopy
Trim Ring
Scroll Bracket
Fan Wires
8
