Casablanca Fan Company C15G624L owner manual Direct - Touch, W-74 Control Installation

Direct - Touch

W-74 Control Installation

Installing the W-74 Wall Control

1 2

0

4 3

NOTE: W-74 Wall Control should only be installed on Casablanca's Direct-TouchTMFans.

The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring.This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:

1. Use only the Casablanca W-74 wall control.	3. Do not use more than one fan per wall control.
2. Do not use any additional control with your	4. No other light fixtures or electrical appliances
Direct-TouchTMfan (for example, dimmer, or fan	may be connected on the circuit controlled by the
speed control).	W-74 wall control.

Single W-74 Installation

CAUTION!

Ensure power is turned OFF at the breaker or fuse panel before starting installation.

1.  If you have multiple Direct-TouchTMfans, refer to the section "changing frequency setting" on page 20.

2.  Remove the screws and switch plate from the existing switch box.

3.  Remove the screws holding the switch in the switch box.

4.  Pull the existing switch from the switch box to expose

	the wire connections.
		W-74
5.  Remove the two wires from the switch.
6.  Connect the BLACK wire from the POWER SOURCE
	that you just removed from the switch to the BLACK/
	WHITE STRIP wire on the W-74 wall control. Secure
	this connection with a wire nut.
7.  Connect the second BLACK wire that you just removed
	from the switch to the second BLACK wire on the
	located on the back of the W-74 wall control. Secure
	this connection with a wire nut.
	NOTE:The RED wire is not used in this
	application. DO NOT remove the crimped
	cap from the wire.
8.  Connect the green ground wire coming
	from the back of the W-74 control to the
	ground wire in the switch box. Secure
	the splice with a wire nut.
9.  Check your work by using the wiring
	diagrams as shown in Figures # 1 and #2.
10.  Install the W-74 in the wall box with the
	two long screws provided.
11.  Install the wall plate with the two white
	screws.

Red

White

Blue

Black/White

Figure 1

2BLACK WIRES

W-74

Wall Control

RED WIRE

NOT USED

	BLACK AND WHITE
Figure 2	STRIPED WIRE

17