Upper Glass Hardware
Upper Glass | Upper Bulb (6) |
|
Upper Glass Assembly
Step 1. Slide the Glass over the upper part of the Fan Assembly.
Step 2. The Glass should rest inside the rim of the lower part of the motor on top of the foam strips to avoid contact with rim.
Rim
Step 3. Remove each of the 6 Upper Bulbs from their packs and Screw into the Bulb Sockets around the top part of the fan.
Note: When replacing bulbs, only replace with max 15 watt bulbs.
Hanging the Fan
Step 1. Trim wires to about 6" from the top of the downrod.
Step 2. Strip 1/2" of insulation off each wire using wire strippers. Raise the fan and place the ball into the hanger bracket.
Step 3. Align the notch on the ball with the indent in the hanger bracket. (Rotate the fan until you hear the notch pop into place.)
Indention
Notch
WARNING: Fan may fall if not assembled as directed in these installation instructions.
10
