Veneto ™
Fan Installation
Getting Started
Installing a New Ceiling Fixture Outlet Box If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
warning!
To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked “Acceptable Fan Support of 22.7 kg (50 lbs.) or less” using the mounting hardware provided with the outlet box or directly to structure.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either the circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure it is marked “Approved for Ceiling Fan Mounting.” If it is not, a new box must be installed.
Note:The weight of this fan is 47 pounds.
Mounting Bracket Installation
Ceiling Hardware (not to scale)
|
| #8 Wood Screw and Washer (2) |
| Mounting Bracket | #10 Wood Screw (2) |
|
| |
|
|
|
|
|
|
|
|
|
Note: After removing the old fixture, check the outlet box to insure that it is supported by a joist or beam across its upper surface. If not, a 2 x4 stud must be installed.
Step 1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box.The pilot holes should be 9/64” in diameter.
Step 2. Thread the lead wires from the outlet box down through the hole in the middle of the ceiling plate.
warning!
Support directly to building structure only.
7
