BASIC IMAGE RECORDING
4.Use [] and [] to select the setting you want, and then press [SET].
To do this: | Select this setting: |
Turn on flash assist | Auto |
|
|
Turn off flash assist | Off |
|
|
IMPORTANT! 
•Flash assist may not produce the desired result for some types of subjects.
•Flash assist may have little effect on your image if you changed any of the following settings when you recorded it.
—Flash intensity (page 71)
—Exposure compensation (EV shift) (page 88)
—ISO sensitivity (page 142)
—Contrast (page 146)
•Using flash assist can cause an increase of digital noise in recorded images.
■ Flash Precautions | Flash |
• Take care that your fingers do not block the flash when you hold the camera.
Covering the flash with your finger can greatly reduce its effectiveness.
•You may not be able to achieve the desired results using the flash if the subject is too close or too far away.
•The flash takes anywhere from a few seconds to as long as 10 seconds to attain full charge after being fired. The actual time required depends on the battery level, temperature, and other conditions.
•The flash does not fire in the modes listed below. The 
(Flash Off) icon on the monitor screen indicates that flash is turned off.
Movie mode, MOVIE BEST SHOT mode
•The flash unit may not be able to charge when camera battery power is low. If this happens, the flash will not fire properly and you will not be able to obtain the desired exposure. Be sure to charge the camera’s battery as soon as possible when power goes low.
72