ADisplaying the Setup Screen

There are two different ways to display the setup screen.

• Pressing the skey

Selecting the “Set:” item on the menu screen that appears when you enter some modes.

The following are the procedures you need to perform to access and use the setup screen using the above operations.

FC-200V

Important!

All of the example procedures presented in this manual use the skey procedure to display the setup screen.

To display the setup screen with the skey

1.Press the skey.

This displays a menu of setup items.

See “Setup Screen Settings” on page E-15 for a complete list of menu items.

2.Use fcto select the setup item whose setting you want to change, and then press E.

This displays a screen for configuring the setting of the setup item you selected.

3.Configure the setting you want.

You can select a setting by with the cursor and then press E, or you can input the number that corresponds to the setting you want to select.

See “Configuring Settings” on page E-16 for information about configuring each setting.

To display the setup screen by selecting “Set:” on a mode menu

Important!

The following procedure is possible only when there is a “Set:” item on the menu that initially appears when you enter a mode. It is not available in all modes.

E-14