Casio WK6500E1B Saving Digital Keyboard Data to a, Memory Card

Using a Memory Card

4. Use the R-17 (t, y) buttons to move the 0 to	3. Depending on the type of data you want to save
“CardFormat”.	to the memory card, perform one of the steps
	shown below.
	• All setup registration banks are saved as a batch. Other
	data is saved in area (data item) units.
	To save this		Do this:
	type of data:
	One user rhythm	1.	Press the L-9 ([F] USER RHYTHMS)
			button.
		2.	Use the dial or R-14(–, +) buttons to
			specify the user rhythm number.
5. Press the R-16 (ENTER) button.
	One user tone	1.	Press the R-12 ([L] USER TONES)
			button.
• This will cause the confirmation message “Sure?” to
		2.	Use the dial or R-14(–, +) buttons to
appear.
			specify the user tone number.
6. Press the R-14 (YES) button to format the
	One user DSP	1.	Perform steps 1 through 4 under “To use
memory card or the R-14 (NO) button to cancel.			a DSP” (page E-36).
		2.	Use the dial or R-14(–, +) buttons to
• The message “Please Wait” will remain on the display
			specify the user DSP number (101
while the format operation is being performed. Do not
			through 200).
perform any Digital Keyboard operation while this
	One user preset	1.	While holding down the L-7 ([D] WORLD/
message is on the display. “Complete” appears on the
			VARIOUS) button, press the L-8 ([E]
display after formatting is complete.
			PIANO RHYTHMS) button to display the
• Formatting may take as long as a few minutes to
			music preset screen.
complete.
		2.	Press the L-9 ([F] USER RHYTHMS)
			button.
Saving Digital Keyboard Data to a		3.	Use the dial or R-14(–, +) buttons to
Memory Card			specify the user preset number.
	One song	1.	Press the C-3 (SONG SEQUENCER)
	sequencer song		button to enter the song sequencer mode.
To save Digital Keyboard data to a memory		2.	Use the dial or R-14(–, +) buttons to
card			specify the song number.
	All registration	Press the C-8 (BANK) button to display the
1. Insert the memory card into the card slot.
	banks	registration bank selection screen.
2. If the Digital Keyboard is in the card mode,	4. While holding down the R-13 (FUNCTION)
press the C-7 (CARD) button to exit the card	button, press the C-7 (LOAD/SAVE) button.
mode.	• This causes an “Xxxx Load”*1 screen like the one
	shown below to appear. The sample screen below
	shows the screen that appears from the rhythm screen.

E-104