Using the Song Sequencer
To adjust the gate time value of a note event
1.Perform steps 1 through 5 under “To adjust the velocity value of a note event” on page
2.Press the
•This will display the setting screen like the one shown below.
•The following explains the meanings and setting ranges
of the
Item name | Description | Setting Range |
Fix | Specifies a fixed value as the | oFF*, |
(Fixed value) | time gate value. 99:95 stands | 00:00 to 99:95 |
| for quarter note 99 beats, 95 |
|
| ticks. |
|
| Select “oFF” for this setting to |
|
| adjust based on the current |
|
| gate time value of each note |
|
| event. |
|
|
|
|
Rate | These settings are enabled | 000% to 100%* to |
(Gate Time Rate) | only when the “oFF” is | 200% |
| selected for the “Fix” setting. |
|
| They change the gate time |
|
| value of each note event |
|
| according to the mathematical |
|
| expression (decimal parts cut |
|
Offset | off) shown below. 00:00 is | |
(Gate Time Offset) | used when the value | +9:95 |
| produced by the expression is |
|
| less than 00:00, and 99:95 is |
|
| used when it is greater than |
|
| 99:95. |
|
| (Current gate time) X(Rate |
|
| setting) + (Offset setting) |
|
|
|
|
3.To change the setting to the desired value, press the
4.In response to the “Sure?” message that appears, press the
To delete a beat event
1.Perform the procedure under “To start an event editor operation” on page
2.Use the
•This displays the “Beat” screen.
3.Use the
4.Press the
•The event at the current cursor position will be deleted as soon as you press the