Important!
The above procedure will not establish a wireless LAN connection if the connection profile of the Data Projector is different from the profile used the first time a connection was established between the computer and Data Projector (Simple Connection 1 in this example). In this case, press the Data Projector’s remote controller [ ] key to display the “Connection Profile” menu and then select the original connection profile (Simple Connection 1 for this example). For details, see “To switch the Data Projector connection profile” (page 66).
Establishing a Wireless LAN Connection with Multiple Computers Using a Manual Connection
This section explains how to connect up to four computers to a single Data Projector (over a wireless LAN access point) at the same time. The following are the general steps that are required.
1Prepare for wireless LAN connection of the Data Projector and the computers (below).
2Create connection profiles for the computers (page 54).
3Use the Manual Connection profile to establish a wireless LAN connection between the first computer and the Data Projector (page 56).
4Use the Manual Connection profile to establish a wireless LAN connection between the other computers and the Data Projector (page 60).
1To prepare for wireless LAN connection of the Data Projector and the computers
1 Install Wireless Connection on all of the computers.
2 Connect
53