Cateye CC-TR200DW (V2c) instruction manual How to install the unit on your bicycle

How to install the unit on your bicycle

1. Attach the bracket to the stem or handlebar

The Flex Tight ™ bracket can be attached to either the stem or the handlebar depend- ing on how the bracket and band are configured.

Caution:

Tighten the dial on the bracket band by hand only.

Over-tightening can damage the screw threads.

When attaching the Flex Tight ™ bracket to the stem

* Attach the bracket with its open end facing to the right.

Bracket band

Bracket rubber pad Stem

2. Mount the speed sensor and magnet

Speed sensor	Wheel magnet
	SPEED
	CADE
	NCE

Cadence magnet

ENG

Bracket

2-1. Temporarily secure the speed sensor

Locate the speed sensor on the left chain stay as shown above, and loosely secure it with the nylon ties.

*Do not tighten the nylon ties completely at this stage. Once a nylon tie is tightened, it cannot be pulled out.

Speed sensor

SPEED

When attaching the Flex Tight ™ bracket to the handlebar

* Attach the bracket with its open end facing to the right.

Bracket band

Handlebar

Bracket rubber pad

Bracket

		Nylon ties
2-2. Mount the magnet
1.	Loosen the setscrews both on the SPEED side	Wheel
	and CADENCE side of the speed sensor, and turn	magnet
	the sensor to the angle as shown on the right.
2.	Temporarily secure the wheel magnet to the	Setscrew on the
	spoke so that it faces the sensor zone on the	CADENCE side
	SPEED side.		SPEED
3.	Temporarily secure the cadence magnet inside Sensor zone
	the crank with nylon ties, so that it faces the	CADENCE	Sensor
	sensor zone on the CADENCE side.		zone

Cut extra length of the band with scissors.

Caution:

Round off the cut edge of the bracket band to prevent injury.

*When the speed sensor is not positioned ap- propriately in respect to the two magnets (in both Steps 2 and 3), move the speed sensor back and forth so that it is positioned properly. After you move the speed sensor, adjust the position so that the two magnets face the rel- evant sensor zone.

4.After adjustment, tighten the nylon ties firmly to secure the speed sensor.

Setscrew on the

SPEED side

Cadence

magnet

Nylon ties

ENG-6 Continue ENG-7