5. Selecting speed unit

Select the speed unit from “km” and “mile”.

1. Select the speed unit.

km mile:

M1/+

 

M2/- (or)

2. After selecting, press the MENU button. The measurement screen appears and the computer set-up is completed.

6. Operation test

Test the functioning of the speed sensor (SPEED) and the cadence sensor (CADENCE).

*If the sensor signal icons, , and are turned off, press the M1/+ or M2/- button to turn them on.

Speed sensor (SPEED)

1. Raise the rear wheel and spin the wheel.

2.

When

flashes on the computer screen and

 

 

 

 

 

 

the speed is displayed, it is operating normally.

 

 

 

 

 

Cadence sensor (CADENCE)

 

 

 

 

1.

Turn the crank.

2. When

flashes on the computer screen

 

 

 

and the cadence is displayed, it is

 

operating normally.

*When or does not flash, the position of the sensor and the magnet is not proper. Check and adjust the position of the sensor and magnet again (page 7).

Important: In the following situations, it is possible that other sensor's ID was picked up; (such can happen when performing ID Synch at the race venue or group rides)

• Does not display values, even though sensor/magnet position is proper

Recommended Action: Go to the computer's ID Synch setup screen

(page 23) and go through the process of ID Synch. (Make sure that here

is no similar devices in the vicinity. Signal transition distance can vary

Basic operation of the computer

Functions on the measurement screen

The measurement screen displays 4 different types of data, which are switched by press- ing the M1/+ and M2/- buttons.

The display data are as follows.

Upper display data

Displays the data related to the speed.

Middle display data

Displays the data related to the cadence.

Switch using the M1/+ button

 

M1/+

Current speed

Average

Maximum

speed

speed

 

Cadence

Average

Maximum

 

cadence

cadence

* Upper and Middle display data are switched in sync together.

Lower display data

Displays the other data.

Switch using the M2/- button

Elapsed time

Trip distance

Countdown

distance

 

 

 

 

M2/-

 

Total time

Date

Lap

Average

Total distance

Clock

lap

number

speed

ENG

from environmental conditions such as weather, buildings, etc)

Sensor signal status

Real time lap data (on-going lap data)

Lap timer

If there is no incoming signal for approximately 5 minutes, the transmission stops

*Pressing and holding the M2/- button while displaying the lap

M2/-

M2/-

and no longer receive the sensor data. Once you press the M1/+ or M2/- button, the computer will come out of the Sleep mode and return to the Stand-by for sensor signal. Signal transmission status can be checked with Signal icon.

(flashing) : Receiving sensor signal

(constant) : Stand-by for sensor signal

(off) : Transmission off

 

timer switches the lap timer to the lap distance. Pressing it again returns to the lap timer.

(2 Sec.)

Lap distance

ENG-14

ENG-15

Page 8
Image 8
Cateye CC-TR200DW (V2c) instruction manual Basic operation of the computer, Selecting speed unit, Operation test