How to install your oven
Ensure that air can flow freely around the housing area.
If the oven is being installed into a fully enclosed built under oven housing unit it may be necessary to cut a small slot in the top of the plinth fitted under the unit.
Cut a section 400 mm wide and a minimum of 15 mm high to allow air to pass under the unit.
Failure to allow adequate ventilation to the appliance may result in over heating or damage to adjacent units.
Lift the oven carefully into position on the shelf, taking care NOT to lift it by the door handle. If you lower the oven door, you will see 4 screw holes, 2 on each side of the oven.
The oven should then be secured to the housing by fitting screws into these holes.
Remember the housing should not be free standing but secured to the wall and/or
adjacent fittings.
50
560
585
Figure 4
560 555
594
594
591
. min 550
540
20
9