CDA WF250SS manual Summary of the Faults, Before Calling for Service

13/ IF OPERATING ABNORMALITIES OCCUR

• SUMMARY OF THE FAULTS

d01: water supply fault (tap)	d07: overflow / anti-leak fault
d02: draining fault	d08: sprinkling distribution fault
d03: heating fault	d11: pressure sensor fault
d04: temperature fault	d12: filling fault (water inlet detection system)
d05: fault – motor under load	d13: overheating fault
d06: fault - motor overload	d14: installation fault : (incorrect drainage
	connection or inadequate flow rate and tap).

• BEFORE CALLING FOR SERVICE

Problem	Possible Causes	What to do?
The door catches when closing	- Appliance not stable	- Adjust the feet.
	- Door not centred on the tub	- Re-centre by adjusting the
		rear feet.
The upper basket does not stay	- Poor manipulation (the basket	- Act more progressively (see
in the high position	is being pulled upwards too	instructions), one side and
	quickly)	then the other.
Small leak around or under the	- Leak from the tap.	- Check that a seal is fitted and
appliance (move the appliance	- Leak from the appliance.	retighten the nut.
to locate the leak)		- Close the water tap and call a
	(Cf. table fault d07).	technician.
Small leak at the door	- Appliance not stable or not level	- Adjust the feet.
	- Door not centred on the tub.	- Re-centre by adjusting the rear
		feet.

31