CDA WF250SS manual Poor Operation, Poor Drying Results

13/ IF OPERATING ABNORMALITIES OCCUR

• POOR OPERATION

Problem	Possible Causes	What to do?
Constant filling	- Drain hole situated too low for	- Drain wand has fallen on the
	the appliance (Cf. table fault	floor.
	d012).
A lot of waste on the large filter	- The filters and drain outlets are	- Remove and clean the filters
at the end of the cycle.	blocked with too much	and the bottom of the drain
	residue.	outlets. Remove large residue
		from the plates before putting
		them in the machine.
Traces of rust on stainless steel	- Quality of the stainless steel ;	- Use “special dishwasher-safe”
	not dishwasher-safe (knives in	cutlery.
	particular)	- Check that the lid on the salt con-
		tainer is closed correctly.

• POOR DRYING RESULTS

Problem	Possible Causes			What to do?
A lot of droplets on the glasses	- Lack or insufficient amount of			- Check the indicator light and
	rinsing product.			fill the tank completely.
	- The dose has not been distrib-			- If the tank is not empty after
	uted.			approximately 60 washings,
				call a technician.
	- Positioning of the items.			- Arrange the items to restrict
				water retention as much as
				possible. Leave the door ajar
				for a few minutes, if possible
Droplets on plastic items, Tefal	- These items have a low calori-			- Arrange the items in the upper
coatings, etc.	fic mass.			basket.
Poorer drying on rapid	- On rapid programmes, the drying			- Leave the door ajar for a few
programmes	temperature and drying period are			minutes.
	reduced to cut down the duration
	of the cycle as much as possible.
Condensation on the wall of the	- Condensation may form on the
inside door or the tub.	walls,	particularly	after the
	appliance has cooled down
	(sound	insulation	increases
	this occurance)

35