INSTALLATION STEP 9

Electrical RequirementsTo avoid installation difficulties, do not run the opener at this time.

To reduce the risk of electric shock, your garage door opener has a grounding type plug with a third grounding pin. This plug will only fit into a grounding type outlet. If the plug doesn't fit into the outlet you have, contact a qualified electrician to install the proper outlet.

WARNING

To prevent possible SERIOUS INJURY or DEATH from electrocution or fire:

•Be sure power is not connected to the opener, and disconnect power to circuit BEFORE removing cover to establish permanent wiring connection.

•Garage door installation and wiring MUST be in compliance with all local electrical and building codes.

•NEVER use an extension cord, 2-wire adapter, or change plug in any way to make it fit outlet. Be sure the opener is grounded.

RIGHT

WRONG

If permanent wiring is required by your local code, refer to the following procedure.

To make a permanent connection through the 22 mm diameter hole in the top of the motor unit:

•Remove the motor unit cover screws and set the cover aside.

•Remove the attached 3-prong cord.

•Connect the black (line) wire to the screw on the brass terminal; the white (neutral) wire to the screw on the silver terminal; and the ground wire to the green ground screw. The opener must be grounded.

•Reinstall the cover.

To avoid installation difficulties, do not run the opener at this time.

PERMANENT WIRING

CONNECTION

Ground Tab

Green

Ground Screw

Ground Wire

Black

Wire

White Wire

Black Wire

24