ONE-PIECE DOORS

Please read and comply with the warnings and reinforcement instructions on the previous page. They apply to one-piece doors also.

•Center the door bracket on the top of the door, in line with the header bracket as shown. Mark either the left and right, or the top and bottom holes.

•Drill 8 mm pilot holes and fasten the bracket with hardware provided.

If the door has no exposed framing, drill 5 mm pilot holes and fasten the bracket with 5/16"x1-1/2" lag screws (not provided) to the top of the door.

NOTE: The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing.) Drill 5 mm pilot holes and substitute 5/16"x1-1/2" lag screws (not provided) to fasten the bracket to the door.

HARDWARE SHOWN ACTUAL SIZE

Nut 5/16"-18

Lockwasher 5/16"

Carriage Bolt 5/16"-18x2-1/2"

Header Wall

38 mm Support

Finished Ceiling

Header

Bracket

Door

Bracket

Optional

Placement

of Door

Bracket

Vertical

Centerline of

Garage Door

Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, aluminum, steel, door with glass panel, etc.) (not provided).

Nut 5/16"-18

Door

Bracket

For a door with no exposed framing, or for the optional installation, use 5/16"x1-1/2" lag screws (not provided) to fasten door bracket.

Lock Washer 5/16"

Top of Door

(Inside Garage)

Top Edge

of Door

Optional

Placement

Carriage Bolt 5/16"-18x2-1/2"

13 mm Socket Wrench

26