OPERATION

IMPORTANT SAFETY INSTRUCTIONS

WARNING

To reduce the risk of SEVERE INJURY or DEATH:

1.

READ AND FOLLOW ALL WARNINGS AND

9.

If one control (force or travel limits) is adjusted, the

 

 

INSTRUCTIONS.

 

 

other control may also need adjustment.

2.

ALWAYS keep remote controls out of reach of

10.

After ANY adjustments are made, the safety reversal

 

 

children. NEVER permit children to operate or play

 

 

system MUST be tested.

 

 

with garage door control push buttons or remote

11.

Safety reversal system MUST be tested every month.

 

 

controls.

 

 

Garage door MUST reverse on contact with 1-1/2"

3.

ONLY activate garage door when it can be seen

 

 

(3.8 cm) high object (or a 2x4 laid flat) on the floor.

 

 

clearly, it is properly adjusted, and there are no

 

 

Failure to adjust the garage door opener properly

 

 

obstructions to door travel.

 

 

may cause SEVERE INJURY or DEATH.

4. ALWAYS keep garage door in sight until completely

12.

ALWAYS KEEP GARAGE DOOR PROPERLY

 

 

closed. NO ONE SHOULD CROSS THE PATH OF THE

 

 

BALANCED (see page 3). An improperly balanced

 

 

MOVING DOOR.

 

 

door may NOT reverse when required and could

5. NO ONE SHOULD GO UNDER A STOPPED,

 

 

result in SEVERE INJURY or DEATH.

 

 

PARTIALLY OPEN DOOR.

13.

ALL repairs to cables, spring assemblies and other

6.

If possible, use emergency release handle to

 

 

hardware, ALL of which are under EXTREME tension,

 

 

disengage trolley ONLY when garage door is

 

 

MUST be made by a trained door systems technician.

 

 

CLOSED. Weak or broken springs or unbalanced door

14.

ALWAYS disconnect electric power to garage door

 

 

could result in an open door falling rapidly and/or

 

 

opener BEFORE making ANY repairs or removing

 

 

unexpectedly, causing SEVERE INJURY or DEATH.

 

 

covers.

7. NEVER use emergency release handle unless garage

15.

SAVE THESE

 

 

doorway is clear of persons and obstructions.

 

 

If rope knot becomes untied, you could fall.

 

 

INSTRUCTIONS.

8. NEVER use handle to pull garage door open or closed.

 

 

 

 

 

 

Using Your Garage Door Opener

6.

If obstructed while opening, the door will stop.

Your Security✚® opener and hand-held remote control

7.

If fully open, the door will not close when the beam is

have been factory-set to a matching code which changes

 

broken. The sensor has no effect in the opening cycle.

with each use, randomly accessing over 100 billion

If the sensor is not installed, or is misaligned, the door

new codes. Your opener will operate with up to eight

won't close from a hand-held remote. However, you can

Security✚® remote controls and one Security✚® Keyless

close the door with the Door Control, the Outside Keylock,

Entry System. If you purchase a new remote, or if you wish

or Keyless Entry, if you activate them until down travel

to deactivate any remote, follow the instructions in the

is complete. If you release them too soon, the door will

Programming section.

reverse.

Activate your opener with any of the following:

The opener lights will turn on under the following

• The Hand-Held Remote Control: Hold the large push

conditions: when the opener is initially plugged in; when

 

button down until the door starts to move.

power is restored after interruption; when the opener is

• The Wall-Mounted Door Control: Hold the push button

activated.

 

or bar down until the door starts to move.

They will turn off automatically after 4-1/2 minutes or

• The Keyless Entry (See Accessories): If provided with

provide constant light when the Light feature on the

 

your garage door opener, it must be programmed

Multi-Function Door Control is activated. Bulb size is A19.

 

before use. See Programming.

Bulb power is 100 watts maximum.

When the opener is activated (with the safety reversing

Security✚® light feature: Lights will also turn on when

sensor correctly installed and aligned)

someone walks through the open garage door. With a

1. If open, the door will close. If closed, it will open.

Multi-Function Door Control, this feature may be turned off

as follows: With the opener lights off, press and hold the

2. If closing, the door will reverse.

light button for 10 seconds, until the light goes on, then off

3.

If opening, the door will stop.

again. To restore this feature, start with the opener lights

4.

If the door has been stopped in a partially open position,

on, then press and hold the light button for 10 seconds

 

it will close.

until the light goes off, then on again.

5.If obstructed while closing, the door will reverse. If the obstruction interrupts the sensor beam, the opener lights will blink for five seconds.

30