H. GATE ARM INSTALLATIONNOTES:

1.All dimensions are measured from one pivot point to the next pivot point.

2.The dimensions shown above are only recommended settings. Your installation may require different dimensions.

3.The SW 2000-X3 can be installed without welding. The anchor, swing arm and drag link may be attached using the supplied hardware only, welded, or bolted and welded.

4.Paint or other anti-rust coating must be applied to the cut areas of the swing arm and/or drag link pipe to prevent rust.

1.Attach gate anchor to gate by welding or using hardware (not supplied).

2.Using manual controls, move the swing arm cap assembly until it points roughly to

the anchor. See Figure 7.

3.Measure and cut the swing arm to length. Attach swing arm to swing arm cap assembly with gate stop on driveway side, using supplied hardware or by welding.

WARNING: Installing gate stop on the wrong side will cause damage to the gate operator.

4.Measure and cut Drag Link pipe to length, then insert spherical rod end assembly into pipe and tighten locking nut.

5.Attach welded end of Drag Link Assembly to Anchor and unwelded end to Swing Arm.

Quick Disconnect

Release Lever

Swing Arm Cap Assembly

Disengaged

Engaged

Figure 7. Gate Arm Installation

10 of 42

Doc 01-20099

Rev F