Install the Door Control

1.5 Position the bottom hole of the door 1.6 Lift the push bar up and mark the top hole. control over the screw and slide

down into place.

1.7Remove the door control from the wall and drill a 5/32 inch (4 mm) hole for the top screw.

1.8Position the bottom hole of the door control over the screw and slide down into place. Attach the top screw.

DRYWALL

Drywall Anchor 6ABx1-1/2"

6-32x1"

GANG BOX

2 Wire the door control to the garage door opener

HARDWARE

Insulated Staple

PRE-WIRED INSTALLATIONS: When wiring the door control to the garage door opener make sure you use the same wires that are connected to the door control.

2.1Run the white and red/white wire from the door control to the garage door opener. Attach the wire to the wall and ceiling with the staple (not applicable for gang box or pre- wired installations). Do not pierce the wire with the staple as this may cause a short or an open circuit.

Staple

2.2Strip 7/16 inch (11 mm) of insulation from the end of the wire near the garage door opener.

7/16"

(11 mm)

2.3Connect the wire to the red and white terminals on the garage door opener. To insert or release wires from the terminal, push in the tab with screwdriver tip.

GREY

WHITE

WHITE

RED

22