Install the Protector System®

1 Install the Safety Reversing Sensors

OPTION C FLOOR INSTALLATION

Use an extension bracket (not provided) or wood black to raise the sensor bracket if needed.

1.1C Carefully measure the position of both

1.2C Attach the sensor brackets to the floor

1.3C Slide the carriage bolt (H17)

1.4C Insert the bolt through the hole in the sensor

sensor brackets so they will be the same

using concrete anchors (not

into the slot on each sensor.

bracket and attach with the wing nut (H18). The

distance from the wall and unobstructed.

provided).

 

lenses on both sensors should point toward

 

 

each other. Make sure the lens is not obstructed

 

 

 

 

(not provided)

 

by the sensor bracket.

 

 

 

DE NSI GARAGE L WA

H17

H18

2 Wire the Safety Reversing Sensors

PRE-WIRED INSTALLATIONS: If your garage

already has wires installed for the safety reversing sensors, proceed to page 26.

HARDWARE

OPTION A INSTALLATION WITHOUT PRE-WIRING

2.1A Run the wire from both sensors to the

2.2A Strip 7/16 inch (11 mm) of

2.3A Insert the white wires into the white terminal on

garage door opener. Attach the wire to

insulation from each set of

the garage door opener. Insert the white/black

the wall and ceiling with the staples.

wires. Separate the wires. Twist

wires into the grey terminal on the garage door

 

the white wires together. Twist

opener. To insert or remove the wires from the

Staple

the white/black wires together.

terminal, push in the tab with a screwdriver tip.

 

 

Insulated Staple

RED

WH TE

WH ET

GREY

7/16"

(11 mm)

25