Door Control

Motion Detecting Control Panel Setup

TIMER-TO-CLOSE (TTC)

NOTE: DO NOT enable TTC if operating a one- piece door. TTC is to be used ONLY with sectional doors.

LOCK

Activate:

Press and hold the LOCK button for 2

LIGHT

To change the amount of time the garage door opener lights will stay on:

Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated by the number of flashes.

MOTION SENSOR

Activate/Deactivate:

Slide the motion sensor switch ON or

The TTC can be turned on or off and the time interval can be adjusted to 1, 5, and 10 minute intervals. Once the TTC has been set and the door is open, the selected close interval will blink and begin to count down to close the door. Activate: Press and hold the ON button until one of the TTC LEDs light up.

Then press the ON button again to cycle through the time interval options (the corresponding TTC

seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time.

Deactivate:

NUMBER OF TIMES GARAGE DOOR OPENER

LIGHTS FLASH

1

2

3

4

TIME THE GARAGE DOOR OPENER LIGHT

STAYS ON

1 1/2 Minutes

2 1/2 Minutes

3 1/2 Minutes

4 1/2 Minutes

OFF.

Motion Sensor Switch

LED will light for each time interval). The garage door opener light bulbs will blink as confirmation.

Deactivate:Press and hold the OFF button until all TTC LEDs turn off and a beep is heard from the motor unit.

Temporarily hold door open (suspend TTC):

Press and release the HOLD OPEN button. Press the HOLD OPEN button again to resume normal TTC operation.

1

Minute,

ON (TTC)

 

5

Minute

 

and 10

OFF (TTC)

Minute

 

TTC LED

HOLD OPEN

 

 

(TTC)

Press and hold the LOCK button again for

2seconds. The command LED will stop flashing and normal operation will resume.

Command

LED

LOCK

Button

To cycle through the time intervals repeat the step above.

LIGHT FEATURE

Deactivate:

Press and hold the LIGHT button until the garage door opener lights turn on, then off again.*

Activate:

Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door opener lights turn off, then on again.*

NOTE: If the command LED is continuously blinking, the LOCK feature needs to be deactivated.

Command LED

LOCK Button

LIGHT Button

* Approximately 10 seconds

Motion Sensor

37