Assembly
4 Install the belt
4.1 Pull the belt around the pulley and toward the trolley. The ribbed side must contact the pulley.
4.2 Hook the trolley connector into the retaining slot on the trolley as shown.
4.3 With the trolley against the screwdriver, dispense the remainder of the belt along the rail length toward the motor unit and around the sprocket. The sprocket teeth must engage the belt.
4.4 Check to make sure the belt is not twisted. Connect the trolley threaded shaft (H1) with the master link (H5).
• Push pins of master link bar through holes in end of belt and trolley threaded shaft (H1).
• Push master link cap over pins and past pin notches.
• Slide clip-on spring over cap and onto pin notches until both pins are securely locked in place.
4.5 Remove the spring trolley nut (H8) from the threaded shaft (H1).
4.6 Insert the trolley threaded shaft (H1) through the hole in the trolley.
HARDWARE
H1
Threaded Shaft with
H8
Spring
Trolley Nut
Sprocket
H5
H1 H5
9
H5
Master Link