Install the Protector System®
OPTION B PRE-WIRED INSTALLATION
2.1B Cut the end of the safety |
| 2.2B Separate the safety reversing sensor wires and strip 7/16 inch (11 mm) of | ||
reversing sensor wire, making |
| insulation from each end. Choose two of the | ||
sure there is enough wire to |
| inch (11 mm) of insulation from each end. Make sure that you choose the | ||
reach the |
| same color | ||
from the wall. |
|
|
| |
|
|
| Safety reversing sensor wires |
|
|
|
| 7/16" | |
|
|
| wires | |
|
|
| (11 mm) | 7/16" |
|
|
|
| |
|
|
|
| (11 mm) |
|
|
|
|
|
2.3B Connect the
| Not Provided |
|
| Yellow |
|
White | (for example) |
|
|
| |
|
| wires |
| White/Black | Purple |
|
| (for example) |
Safety reversing sensor wires
2.4B At the garage door opener, strip 7/16 inch (11 mm) of insulation from each end of the wires previously chosen for the | 2.5B Insert the wires connected to the white safety sensor wires to the | |
safety reversing sensors. Twist the | white terminal on the garage door opener. Insert the wires that are | |
| connected to the white/black safety sensor wires to the grey | |
| terminal on the garage door opener. | |
| Yellow | Purple |
Yellow | (for example) | (for example) |
Purple |
|
|
| DER WH TE WH TE | GREY |
7/16" |
| To insert or remove |
(11 mm) |
| |
| the wires from the | |
|
| |
|
| terminal, push in the |
|
| tab with a screwdriver tip. |
26