Setup
-8- Legend 300E Spot User Manual Rev. 01g
Gobo Replacement
The gobos in the Legend 300E S pot’s gobo wheel ar e rem o vable from their gobo plates .
This operation is quite simp le, although it requires t he technici an to be caref ul and to
follow the recommended proced ure.
· Make sure to disconnect the fixture ’s power cord before replacing a gobo
· Always replace a gobo with a gobo of the same dimension s.
· When inserting a glass gobo, al ways make sure t hat the shin ny side of the
gobo (glass base) faces the lamp . This prov ides a layer of protecti on again st
the high temperature from the lamp.
Procedure 1) Turn the fixture off and d isconnect it from the p ower outlet.
2) Open the head cover b y loosening the four f astening screws at the sides of the top
cover.
3) Separate the gobo pl ate away from the gobo wheel by pushing it t oward the front of
the moving head (direction 1 in the diagram). Be carefu l not to push the gobo out of
the gobo plate.
4) Extrac t the gobo plate by pulling it outward (direction 2 in the diagram).
5) On a flat surface, rem ove the expansion rin g that holds the gobo in place and
remove the gobo from the gobo plat e.
6) Insert a new gobo and hold it in place with the expansion ring.
7) Slide the tip of the gobo plate under the pressure plate near th e center of the gobo
wheel.
8) Push the gobo plate i nwards. DO NOT force t he gobo plate into th e gobo wheel slot.
If correctly installed, the gobo plate should accommodate itself in the gobo wheel
slot.
Gobo Replacement
Diagram