Operation
-14- Legend 300E Spot User Manual Rev. 01g
Lamp Settings From the Main Menu, hig hlight Fixture Settings and press <E NTER>.
The lamp will not ignite if the ambi ent temperature is 104º F (45º C) or higher.
Lamp On / Off
1) Highlight On/Off (the current setting will sh ow).
2) To turn the lamp on or off, press <E NTER> (a pop up window will op en).
a) Select ON to turn the lamp on or OFF to turn t he lamp off.
b) Accept the selected option.
Lamp Status During
Power On
1) Highlight State/Power On (the curr ent setting will show).
2) To change the lamp st atus during power on, press <ENTER> ( a pop up w in d ow wi ll
open).
a) Select ON to turn on the fixture and the lamp simultaneous ly or OFF to turn on
the fixture without tur ning on the lamp.
b) Accept the selected option.
Remote Turn Off 1) Highlight Off Via DMX (the current setting will show).
2) To enable/disable remote tur n off, press <ENTER> (a pop up window will open).
a) Select Y ES to enable fixture turn off from eith er a DMX c ontr oller or its power
switch, or NO to turn the fixtur e off only from its pow er switch.
b) Accept the selected option.
Lamp On if DMX Present
1) Highlight On if DMX On (the current setting will show).
2) To turn the lamp on w hen DMX is present, press <E NTER> (a pop up window will
open).
a) Select Y ES to turn the lamp on if D MX signal is present, or NO to turn the lamp
on only from the control panel.
b) Accept the selected option.
Lamp Off if DMX Absent 1) Highlight Off if DMX Off (the current s etting will show).
2) To turn the lamp off when DMX is abs ent, pr ess <ENTER> (a p op up win d ow wi ll
open).
a) Select Y ES to turn the lamp off if DMX signal is absent, or NO to turn the lamp
off only from the control panel.
b) Accept the selected opt i on.
Fan Speed 1) Highlight Cooling Mode (the current setti ng will show).
2) To change the fan sp eed setting, press <E NTER> (a pop up window wi ll op en) .
a) Select AUTO to allow the fi xture’s controller to s et the fan speed, or HI GH to set
the fan speed to high mod e.
b) Accept the new select ion.
Lamp Strike Delay
1) Highlight Ignition Delay (the current setting will show).
2) To set the lamp strik e delay, press <ENT ER> (a pop up window will open).
a) Select the delay before the lamp strikes after power up in s econds (0~255).
b) Accept the new value.
Fixture Shut Off Delay
1) Highlight Low Power Delay (the current s etting will show).
2) To set the lamp shut off delay, press <ENT ER> (a pop up window wil l op en) .
a) Select t he delay before t he fixture powers off after lamp off in second s (0~255).
b) Accept the new value.