Mounting
Orientation | The Scorpion™ GBC 2.0 and RGY units may be mounted in any position, provided |
Rigging | there is adequate ventilation. |
Be sure that the structure onto which you are mounting this product can support its | |
| weight. See the Technical Specifications section of this manual for weight information. |
| Mount the product securely. You can do this with a screw, a nut, and a bolt. You could |
| also use a mounting clamp if rigging this product onto a truss. Always use a safety |
| cable. Consider ease of access to the unit for maintenance and programming purposes |
| before deciding on a location for this product |
| When power linking multiple products, always consider the length of the power linking |
| cable and mount the products close enough together for cables to reach. |
| The bracket adjustment knobs allow for aiming the product to a desired angle. Do not |
| use tools to loosen or tighten the bracket knobs because tools can damage them. |
Hanging Bracket 
Bracket Adjustment Knob (1 of 2)
Mounting Diagram
Safety Loop
Proper Use This product is for overhead mounting only. For safety purposes, CHAUVET® recommends mounting your lighting effect products on steady elevated platforms or sturdy overhead supports using suitable hanging clamps. In all cases, you must use safety cables. You can obtain appropriate mounting hardware from your distributor.
International laser safety regulations require that laser products must be operated in the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and the lowest laser light vertically. Additionally, 3 meters of horizontal separation is required between laser light and audience or other public spaces.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
Scorpion™ GBC 2.0/RGY User Manual (Rev. 2 ML) | Page 11 of 52 |
