Chevrolet 2008 owner manual License Plate Lamp, Back-up Lamp

Back-up Lamp

1.Open the trunk. See Trunk on page 2-13for more information.

2.Remove the wing nuts holding the trunk trim.

3.Turn the bulb socket counterclockwise to remove from the lamp assembly.

4.Pinch the connector tab to remove connector from bulb assembly.

5.Snap connector into the bulb assembly.

6.Reverse Steps 1 through 3 to reinstall.

License Plate Lamp

To replace the license plate lamp bulb:

1.Turn the two screws that hold the license plate lamp assembly counterclockwise to remove them.

2.Turn and pull the license plate lamp forward through the fascia opening.

3.Turn the bulb socket counterclockwise and pull the bulb straight out of the socket.

4.Push the new bulb in and turn it clockwise to install.

5-50