Instruction Manual | Plasma Display Electric |
|
|
TROUBLESHOOTING
If the lift is installed according to these instructions, it should operate
|
| Possible |
|
|
Symptom(s) |
| Causes | Suggested Action | |
No Movement and No |
| No Power | 1. Check power to unit (supply, cord, activation | |
Sound |
|
| control, and connections). | |
|
|
| No power: Provide power, repair cord, tighten | |
|
|
|
| connections or repair activation control. |
|
|
| Power: | Check fuse on circuit board. If fuse is OK, |
|
|
|
| proceed to next step. |
|
| Faulty Circuit Board | 2. Check circuit board as follows: | |
|
|
| Make three jumper wires with ends stripped. | |
|
|
| Install one jumper wire on terminal 11. | |
|
|
| Install one jumper wire on terminal 12. | |
|
|
| Install one jumper wire on terminal 13. | |
|
|
| Momentarily touch jumper wire from terminal 11 to | |
|
|
| terminal 13. Unit should extend. | |
|
|
| Momentarily touch jumper wire from terminal 12 to | |
|
|
| terminal 13. Unit should retract. | |
|
|
| Activates |
|
|
|
| In both |
|
|
|
| Directions: Circuit board OK, faulty activation | |
|
|
|
| interface. Check remote switch, circuit, or |
|
|
| Unit | batteries in remote control. |
|
|
|
| |
|
|
| Fails |
|
|
|
| Both/Either | |
|
|
| Direction: Call Chief Manufacturing. | |
Unit Operates Noisily |
| Track Misalignment | 1. Check for noise and/or metal shavings in track | |
(Squeeling or grinding) |
|
| Noise or |
|
|
|
| Shavings: Check and adjust track and/or shelf as | |
|
|
| No Track | necessary. |
|
|
|
| |
|
|
| Noise: | Possible brake problem, call Chief |
|
|
|
| Manufacturing |
19
