Instruction Manual

Plasma Display Electric Pop-Up Lift

INSTALL THE DISPLAY ON THE LIFT

Attach Brackets to the Display

1.Follow the instructions accompanying the PSB brackets designed for your display.

Mount the Display

1.Remove 4 screws and slide back panel cover up and out (see Figure 11).

2.Make sure the latch on the mount is lowered to the side before attempting to place the display on the mount (see Figure 12).

3.With the aid of another person, lift the display up to the mount, aligning the PSB mounting buttons on the display with the teardrop slots on the mount, and set the plasma into place.

CAUTION: If the latch does not travel to the full upright position, remove and reset the display.

4.While supporting the display, raise the latch.

5.Install Q-clamp (see Figure 13).

6.Install back panel cover and secure using 4 screws.

Remove screws

Figure 11. Back Panel Cover Removal Latch Lowered

Raise Latch to Secure Display

Tear Drop Slots

Figure 12. Latch and Tear Drop Slots

Q-clamp

Figure 13. Install Q-clamp

10

Page 11
Image 11
Chief Manufacturing 8805-000009 manual Install the Display on the Lift, Attach Brackets to the Display, Mount the Display