Instruction Manual | Plasma Display Electric |
|
|
Remote (RC-10)
Circuit Board Box Assembly
Figure 21. Contacts Connection
Wire for remote (RC-10) operation as follows (see Figure 21):
1.Install a jumper wire between terminals #6 and terminal #2 (see Figure 22).
2.Connect the white wire of the RC-10 controller unit to terminal #1 (see Figure 23).
3.Connect the red wire of the RC-10 controller unit to terminal #2.
4.Connect the black wire of the RC-10 controller unit to terminal #5.
5.Connect the power source to the lift.
NOTE: If the unit does not activate, check to make sure the 9 volt battery is working and make sure the dip switches in the send- ing unit match the dip switch settings in the controller unit (see Figure 24).
Figure 22. Contacts Connection
Red lead | Black lead |
Figure 23. Contacts Connection
Figure 24. Dip Switches
15
