Instruction Manual | Plasma Display Electric |
4.With the extended position finish piece and the plasma- mounted, lower the unit to its fully retracted position.
5.Place the side pieces in position (do not attach).
6.Place the top piece in position (do not attach).
7.Measure the distance from the top surface of the top piece to the top surface of your furniture and cut this dimension from each side piece (see Figure 8).
8.Remove and assemble finish pieces (bottom, sides and top), making sure your finished box is square.
CAUTION: A backing is recommended for support. Frame move- ment could result in damage to the frame, damage to the lift, and damage to the plasma.
CAUTION: Check plasma ventilation requirements. Provide ven- tillation for your application.
9.Measure box, construct a backing for lateral support, and install backing.
WARNNG: Be aware during the installation that this is a motorized device, and there are pinch points for people and for electrical wiring. Keep hands and electrical wiring away from internal components of the mechanism
CAUTION: Failure to allow clearance for the finish pieces to retract to the fully lowered position may result in damage to the finish pieces, damage to the lift, and damage to the plasma.
10. Carefully, without plasma mounted on lift, operate lift to ensure the finish pieces have sufficient clearance during full travel
and that top finish piece is flush with the furniture top when fully retracted.
Retracted Position | Backing | |||
Finish Piece | ||||
|
| |||
|
|
|
| |
|
|
|
| |
|
|
|
| |
Side Pieces
Plasma
Extendeded Position
Finish Piece
Figure 7. Retracted Position Finish Piece
Finish Piece |
Furniture |
Figure 8. Side Piece Dimensions
8
