11
CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from
computers and video equipment. 3-built-in Terminal Slots enable you to arrange desired combinations of input sources just
by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.
Screws
Guide
Socket
Plug
Figure shows HDB 15-PIN terminal (Optional parts).
Pull out terminal by holding handle.
Remove 2 Screws on terminal.
1
2
REPLACEMENT OF TERMINAL
Tighten screws to secure terminal.
Replace terminal. Insert terminal along Guide to fit Plug
into Socket.
3
4

NOTES ON ORDERING OR USING

OPTIONAL INTERFACE BOARD

When ordering or using Optional Interface Board(Terminal Board), contact your sales dealer. When con-tacting the sales dealer, tell the Optional ControlNumber (Op.cont.No.) in the menu that is located underLanguage Select Menu. (See page 33.)NOTE; When replacement of terminal board, MAINON/OFF switch should be OFF position.
CONTROL PORT
INPUT 1
R/C JACK
USB
RESET
(MONO)
(MONO)
AUDIO
INPUT 2INPUT 3
SERIAL PORT IN SERIAL PORT OUT
AUDIO OUT
RL
L
RL
ANALOG RGB
INPUT/OUTPUT
TERMINALS
HDB 15-PIN Terminal
TERMINAL SLOT (Factory set)