12
CONNECTING PROJECTOR
CONTROL PORT
INPUT 1
R/C JACK
USB
RESET (MONO)
(MONO)
AUDIO
INPUT 2INPUT 3
SERIAL PORT IN SERIAL PORT OUT
AUDIO OUT
RL
L
RL
ANALOG RGB
This port is used to service
this projector.
Connect an audio output
from computer to these
jacks. (Refer to P13.)

CONTROL PORT CONNECTOR

AUDIO INPUT JACKS

INPUT/OUTPUT TERMINALS AND JACKS
Connect computer output
(Analog HDB 15-pin type) to
this terminal.
(Refer to P13.)

HDB 15-PIN INPUT TERMINAL

Connect an external audio
amplifier to these jacks.
(Refer to P13.)

AUDIO OUTPUT JACKS

This projector uses a micro processor
to control a unit. Occasionally, this
micro processor may malfunction and
need to be reset. This can be done
by pressing RESET button with a
pen, which will shut down and restart
unit. Do not use RESET function
excessively.

RESET BUTTON

USB PORT (Series B)

SERIAL PORT

OUT TERMINAL

SERIAL PORT

IN TERMINAL

This port is used to service
this portt.
If you control a projector by computer,
you must connect a cable (not
provided) from your computer to this
terminal.
This terminal outputs signal from
SERIAL PORT IN. More than two
projectors can be controlled with one
computer by connecting SERIAL
PORT IN. of another projector to this
terminal.